Through its Borg & Beck brand, First Line Ltd says it believes in the importance of promoting best practice during brake installation.
By following the correct procedures, possible complaints will be significantly reduced, saving time and inconvenience for both technicians and their customers. There are three main habits that some still adopt during installation, that if not corrected, can cause potential issues.
Firstly, First Line says, the use of copper grease on the back of brake pads is a definite no. This can lead to complaints of noise and possibly affect the free movement of the pads. This is because Borg & Beck brake pads have double rubber shims on the back to absorb any noise and vibration, therefore there is no need to apply anything else to the back of the pads, as this will be detrimental to their functioning.
Secondly, it is vital that the mounting surface of the disc and the vehicle’s hub are totally clean and free of rust and debris. The hub should be cleaned using a soft wire brush or emery paper, then wiped with a cloth and solvent. A small amount of debris not cleaned away can cause an instant problem of excessive run out, which will be felt through the steering wheel.
First Line says best practice to check if the discs are parallel to the hub, is to check the run out of the discs. This should not exceed 0.08mm, if the run out exceeds this, the disc must be removed and the hub cleaned again. If this has no effect, the hub should be measured for run out as well. Hub run out in excess of 0.04mm is likely to cause a problem and should be investigated.
Thirdly, when new pads and discs are installed together, they must be bedded-in properly to ensure a great pedal feel and promote longevity of the components. Failure to drive sensibly for the first 650 km could lead to a hot-spotting incidence, which if severe will induce Disc Thickness Variation (DTV), a problem that develops over a few thousand kilometres before being felt.
All of this advice is repeated on the Borg & Beck ‘Install With Confidence’ poster designed to help remind technicians and enable them to relay these messages to their customers. Free copies of which are available by emailing: email@example.com.
In addition, a rear-view mirror hanger has been designed and is being put in the box with the Brake Discs, so that they can be placed in the vehicle after installation to encourage the driver to ‘Take it easy’.